Question about car alignment

stinkynuts

Super
Jan 4, 2005
8,939
3,220
113
Whenever I let go of the steering wheel, my car drifts to the right. I've noticed this about every car I've driven. Is this intentional so that if you fall asleep, you don't go into oncoming traffic, or do is it a bad alignment job? Shouldn't it go perfectly straight?
 
Roads are typically crowned in the centre to promote positive drainage laterally off of the road and into the gutters (I.e. they are paved in an inverted V shape.)

Though depending on road width, the crown could be on the line between the first and second lane, or elsewhere. Typically city streets though are crowned at the centre line.

This will cause your car to pull right, though car alignments are usually set to counteract road crown, however road crown varies, it is not always crowned in the centre, and the road will spiral into the circular curve and in the circular curve, the road is superelevated and not crowned. (Superelevated = banked in layman's terms) And superelevation will always be high in the direction of the outside of the curve.

If your car pulls "too much" though, you do have an alignment problem.
 
You need an alignment when your vehicle has uneven or rapid tire wear, pulling or drifting away, wandering on a straight road and the spokes of a stearing wheel off centre. Bad alignment job. Depending what kind of vehicle you have you can not always adjust the camber/caster/toe though the technician should be able to be dead on if not close and there be a print off with your invoice.
 
Check the tires for uneven wear. They will show you if the alignment is out or if you have a ball joint problem.

Most shops only adjust for toe for a couple of reasons:

1. It is the one people can see and feel. If the vehicle steers in one direction, or the wheel isn't centred, drivers complain.

2. Sometimes it is the only adjustment that can be done easily.

Toe only requires twisting tie rods. Very easy.

Camber and caster adjustment used to be done on the old cars by adding and removing shims on the upper a arms. This is no longer possible in some cars because there are no upper A arms. Macpherson struts occupy the front suspension of 90% of the cars out there. Camber is adjusted by adjusting the two bottom bolts in where the macpherson strut connects to the steering knuckle. When the car leaves the factory, camber is usually good because tolerences are tight enough that this doesn't have to be adjusted.

3. Special bolts or plates (meaning $$ for parts and more labour) may be needed for adjustment.

Once the car gets old and needs a new set of struts or has been in a collision, the lower bolts sometimes need to be replaced with special oblong bolts that allow for a greater range and easy adjustment. If no bolts are available, or you are being cheap, the lower bolt holes in the strut are ground out to get the proper camber.

Caster is out on many, many cars from the factory. This is the adjustment that is least noticeable to the driver because it is not a big source of tire wear. To adjust this, the holes in the upper strut mount holes need to be ground out or a special camber plate put on the car.

It is not unusual for the alignment to be out on the rear of a car brand new and for this to be out for the entire life of the car because people don't get the feedback through the steering wheel. Independent rears are easy to adjust because they have tie rods and I have this done when it needs it.

Adjusting the rear alignment on a solid axle car requires shims. As long as the tires wear evenly, most people won't care or notice and many, including myself won't spend the money to bring a solid axle back into spec.
 
Whenever I let go of the steering wheel, my car drifts to the right. I've noticed this about every car I've driven..... Shouldn't it go perfectly straight?
Make sure you do your road test on a flat level road.
If you are on a level road with no crown, yes it should go straight.

How old is the car and tires?
I've had cars a couple years old with tires pretty well worn that pulled to either side and it turned out to be just fairly worn tires out of balance. When I finally got new tires the car went straight again on a level road, just like new again. No alignment was needed.

Used to get routine alignments years ago because I thought they were necessary. Then Consumers Reports started doing reports on how most of these routine alignments were a waste of money and unnecessary. CR stated most vehicles only need alignments if you did some damage to the front end or hit a big pothole badly. From that point on I stopped getting all those routine alignments.
 
Checking pressures is the cheapest and simplest thing to do. Tire pressures are checked and monitored before a car is put on an alignment rack. A 5 psi difference won't cause a car to pull. Even 10 may not be noticeable, but it's important to check pressures regularly because low tire pressure is why blowouts occur. It's better to be 5 pounds over the recommended pressure than 1 pound under.

Tires can also "settle", which can cause a car to pull in one direction. This is noticeable when you put used tires on the car, or rotate tires that have been turning in one direction that have missed their rotation a couple of times and then put on the opposite side of the car. If you let go of the steering wheel and the steering wheel immediately pulls in one direction, it could be low pressure or settled tires.
 
Is your car new ?

Are your tires new ?

Depends which road you are on and which lane you are in. You may notice driving on the left lane sometimes pulls the car to the left. Its because of the design of the road and the grading of the road so that water goes towards the gutters.

However, many people have given great suggestions.

Chcek your tire pressure too. if you have more questions feel free to PM me or ask here.
 
Make sure you do your road test on a flat level road.
If you are on a level road with no crown, yes it should go straight.

How old is the car and tires?
I've had cars a couple years old with tires pretty well worn that pulled to either side and it turned out to be just fairly worn tires out of balance. When I finally got new tires the car went straight again on a level road, just like new again. No alignment was needed.

Used to get routine alignments years ago because I thought they were necessary. Then Consumers Reports started doing reports on how most of these routine alignments were a waste of money and unnecessary. CR stated most vehicles only need alignments if you did some damage to the front end or hit a big pothole badly. From that point on I stopped getting all those routine alignments.

How often do you need an alignment? It's one of those questions where the answer is "it depends." Along with hard hits to the tire and collision damage, I get an alignment every time I get a new set of tires or I start to see abnormal tire wear. The car's alignment starts to go out basically as soon as you hit the road. The larger the car, the longer it takes for the alignment to go out because the parts are beefier and can absorb hits better than small cars.

Woodpeckr is saving money by not going for routine alignments. His alignment is probably out (along with everyone else's), but as long as it doesn't show in tire wear, it's not necessary to get it aligned as often as shops would like you to.
 
I haven't gotten any alignments since reading that CR report in the early 80s. I rotate tires every 7500 miles and see no abnormal tire wear and have been lucky not to have had any damage or collision damage that would require an alignment.....knock on wood....:wink:

FWIW: I usually drive ~20,000-30,000 miles/yr...
 
Last edited:
It in part also depends upon how much driving you do. People who put a lot of kilometers/miles on a car are going to go through a lot more tires without having an alignment every so often (that probably means six-eight months), however, if you principally drive around Toronto and don't put 30,000 - 40,000 kilometers per year on the car, you can probably get way with not having an alignment before you replace the tires.
 
I did go to school for motive power and have my A class... I love hands on :p