Check the tires for uneven wear. They will show you if the alignment is out or if you have a ball joint problem.
Most shops only adjust for toe for a couple of reasons:
1. It is the one people can see and feel. If the vehicle steers in one direction, or the wheel isn't centred, drivers complain.
2. Sometimes it is the only adjustment that can be done easily.
Toe only requires twisting tie rods. Very easy.
Camber and caster adjustment used to be done on the old cars by adding and removing shims on the upper a arms. This is no longer possible in some cars because there are no upper A arms. Macpherson struts occupy the front suspension of 90% of the cars out there. Camber is adjusted by adjusting the two bottom bolts in where the macpherson strut connects to the steering knuckle. When the car leaves the factory, camber is usually good because tolerences are tight enough that this doesn't have to be adjusted.
3. Special bolts or plates (meaning $$ for parts and more labour) may be needed for adjustment.
Once the car gets old and needs a new set of struts or has been in a collision, the lower bolts sometimes need to be replaced with special oblong bolts that allow for a greater range and easy adjustment. If no bolts are available, or you are being cheap, the lower bolt holes in the strut are ground out to get the proper camber.
Caster is out on many, many cars from the factory. This is the adjustment that is least noticeable to the driver because it is not a big source of tire wear. To adjust this, the holes in the upper strut mount holes need to be ground out or a special camber plate put on the car.
It is not unusual for the alignment to be out on the rear of a car brand new and for this to be out for the entire life of the car because people don't get the feedback through the steering wheel. Independent rears are easy to adjust because they have tie rods and I have this done when it needs it.
Adjusting the rear alignment on a solid axle car requires shims. As long as the tires wear evenly, most people won't care or notice and many, including myself won't spend the money to bring a solid axle back into spec.