Bell satellite to home cable system

sailorsix

New member
Sep 25, 2006
1,338
0
0
I have run another wire into the house from the silver box attached to our dish.
TV works fine when hooked up to this wire.
I then ran an extension to the hydro panel where the Rogers wires come into t he house (they are disconnected from the house wires one of which goest o live Rn other to master bedroom.
Signal does not reach bedroom.

Any suggestions on signal booster?
 
I have run another wire into the house from the silver box attached to our dish.
TV works fine when hooked up to this wire.
I then ran an extension to the hydro panel where the Rogers wires come into t he house (they are disconnected from the house wires one of which goest o live Rn other to master bedroom.
Signal does not reach bedroom.

Any suggestions on signal booster?

I think what you are saying is that you ae running a cable from the sat to the rogers box where you are then attaching the sat cable to the cable that was used for the rogers extention. This should work with nothing else required. The only thing I can think of is you have connected the wrong cables at the rogers box or connected to a wire that does not go to the masterbedroom and you are mistaken. A booster will not help at all if you are getting no signal at all.
 
Sorry I mislead you....Ted fuckhead Rogers is nowhere in my life nor my basement other than where his cabel wires stick through the basement wall at the panel. They used to be hooked up to the two coax cables that run to the two outlets inthehouse...one in the living room and one in the bedroom.

I have run a cable from the dish to inside the house. The tV works there.

I then ran it to the panel where I connected it to the house wires but I get no signal when I connect the TV to the bedroom outlet. There is a little bit of a spark when I connect to the wall outlet but that is it.
 
I was always under the impression that the line from the dish had to be connected directly to the receiver. You couldn't run it through a splitter before the receiver (which I would assume is in the panel).