DoFo government admits new licence plates 'absolutely' a problem, will need to be rec

They are just switching back to the white number plates except having Dumb DOFO's slogan on it. Just a screw up by the Dumb DOFO Government, and they are hiding the actual costs of this stupid idea of his. Hence the NDA, and hope Andrea Horwath just pursues it until the full truth is disclosed. You are just kidding yourself and no one else, as once again you have lost the argument!!

Isn't the new slogan and non-raised letters not enough change for you?
So every government who issues new plates is stupid even though the existing plates were defective? If that was the case, wouldn't we have the same design in place for the past 100 years? So why is it dumb of Ford to change them and no one else before him?
Do you not realize that plates have been blue with white letters many times over the years? So nothing revolutionary about having white letters instead of blue.

150px-1971_Ontario_License_plate.jpg
 
Isn't the new slogan and non-raised letters not enough change for you?
So every government who issues new plates is stupid even though the existing plates were defective? If that was the case, wouldn't we have the same design in place for the past 100 years? So why is it dumb of Ford to change them and no one else before him?
Do you not realize that plates have been blue with white letters many times over the years? So nothing revolutionary about having white letters instead of blue.

150px-1971_Ontario_License_plate.jpg


So much squirming.
So much squirming.
 
Not quite.
Even child car seats get distributed and then defects are found later and they are recalled and re-designed. What's the difference?

For starters: They don't keep handing out defective child seats once they know they are defective.
I could keep going, but it would be lost on you.
You still don't even know what the definition of 'contingency' is.
 
Isn't the new slogan and non-raised letters not enough change for you?
So every government who issues new plates is stupid even though the existing plates were defective? If that was the case, wouldn't we have the same design in place for the past 100 years? So why is it dumb of Ford to change them and no one else before him?
Do you not realize that plates have been blue with white letters many times over the years? So nothing revolutionary about having white letters instead of blue.

150px-1971_Ontario_License_plate.jpg

Again you do not seem to grasp the very basic fact that these blue plates were sent in advance to the Ontario Government for their final approval prior to the actual production of them. It is at that stage that the Ontario Government should have got their lazy asses off the couch to assess them before their final approval. There was absolutely no defect if that is what they approved. If it was as visible as the white number plates to start with and over the months or years became less and less visible, then you could say yes there is a manufacturing defect. But this was from day 1 when it was fully approved. Maybe, now you get it. The 1970 number plates were a totally different make at that time and there were no defective issues to start with!!

cutscutssmall.JPG
 
For starters: They don't keep handing out defective child seats once they know they are defective.
I could keep going, but it would be lost on you.
You still don't even know what the definition of 'contingency' is.

What plates do you expect them to hand out in the meantime? No more old ones and there still is a need to issue plates.
So what’s your contingency if no more old plates available?
 
Again you do not seem to grasp the very basic fact that these blue plates were sent in advance to the Ontario Government for their final approval prior to the actual production of them. It is at that stage that the Ontario Government should have got their lazy asses off the couch to assess them before their final approval. There was absolutely no defect if that is what they approved. If it was as visible as the white number plates to start with and over the months or years became less and less visible, then you could say yes there is a manufacturing defect. But this was from day 1 when it was fully approved. Maybe, now you get it. The 1970 number plates were a totally different make at that time and there were no defective issues to start with!!

By your definition there would be no such thing as product recalls be it cars or child seats. But this happens all the time despite testing.
So why would this be different?
 
You're right!
Druggie didn't have a contingency plan and didn't put one in place when he first heard there were issues with his redesign.

Contingency is to replace something that has a defect just like all companies do with their products.
Too complicated for you?

If there’s a recall on your car despite all the vigorous safety testing car manufacturers perform, what makes that any different?
 
Contingency is to replace something that has a defect just like all companies do with their products.
Too complicated for you?

If there’s a recall on your car despite all the vigorous safety testing car manufacturers perform, what makes that any different?

Its not a defect when 3M made the plates per Druggie's design and then had him proof them.
Its Druggie that decided to pretend they were fine and then eventually recall them all.
Not 3M.

Good thing you'll never hire a contractor. I'm sure it would got like 'yes, I really do want my kitchen counters covered in tin foil' followed by 'obviously that's a build problem and you need to replace it with marble'.
 
Its not a defect when 3M made the plates per Druggie's design and then had him proof them.
Its Druggie that decided to pretend they were fine and then eventually recall them all.
Not 3M.

Good thing you'll never hire a contractor. I'm sure it would got like 'yes, I really do want my kitchen counters covered in tin foil' followed by 'obviously that's a build problem and you need to replace it with marble'.

If your point of reference for commercial contracts is home improvement contracts, no wonder you can't comprehend what the manufacturer was likely responsible for, and what aspects of the design were approved by Cabinet, and when.
 
By your definition there would be no such thing as product recalls be it cars or child seats. But this happens all the time despite testing.
So why would this be different?

What are you still waffling about? The cars and their child seats etc are not owned by the Ontario Government but just the manufacturers. If there was a problem right away then they would NOT have approved of their use. It is far more complicated than a visual number plate that all the Government who took ownership of it, should have done was to install it on a car and tested it. They then should have then got the RCMP / Police approvals as it is applies to their daily monitoring. But they still approved it although it had an issue from Day 1, that had nothing to do with a manufacturing defect!!
 
If your point of reference for commercial contracts is home improvement contracts, no wonder you can't comprehend what the manufacturer was likely responsible for, and what aspects of the design were approved by Cabinet, and when.

So you are saying that the Ontario Government had no responsibility for approving the design as well as materials plus texture / colour of it, when clearly the Pre-Production or Pilot plates would have been submitted in advance prior to their approval and go ahead to manufacture them??
 
So you are saying that the Ontario Government had no responsibility for approving the design as well as materials plus texture / colour of it, when clearly the Pre-Production or Pilot plates would have been submitted in advance prior to their approval and go ahead to manufacture them??

Cabinet, after vetting by bureaucrats, would have approved the design based on assurances from the manufacturer that the materials and production process would be appropriate to the intended use. I'm pretty sure they didn't turn the lights off in Queens Park and check out the prototypes with flashlights. Doug Ford, contrary to your belief, did not slap on a set of prototype plates and then go driving around at night with the OPP checking them out with their various squad car beams!

Turns out that the materials used were not appropriate for the intended use. Looks like the bureaucrats and the manufacturers screwed up. But it's not that big a deal. Happens all the time when new products are released by manufacturers. Probably an easy fix with not too much investment in retooling.

Your theory as to the level of micromanagement by Cabinet over this project is laughable.
 
Cabinet, after vetting by bureaucrats, would have approved the design based on assurances from the manufacturer that the materials and production process would be appropriate to the intended use. I'm pretty sure they didn't turn the lights off in Queens Park and check out the prototypes with flashlights. Doug Ford, contrary to your belief, did not slap on a set of prototype plates and then go driving around at night with the OPP checking them out with their various squad car beams!

Turns out that the materials used were not appropriate for the intended use. Looks like the bureaucrats and the manufacturers screwed up. But it's not that big a deal. Happens all the time when new products are released by manufacturers. Probably an easy fix with not too much investment in retooling.

Your theory as to the level of micromanagement by Cabinet over this project is laughable.

If the Government are purchasing thousands of licence plates, you are telling me the they would not get a sample of that plate in advance especially if it is customized to suit the Government's choice??

The assurances from manufacturers will be in the form of warranty that they will operate as such based on what was submitted to the customer in advance of the mass production of them. Any company that buys such products that they will be reselling, will expect to see and to test out that quality prior to approval for the manufacture of these products. If they do not follow these basic protocols then they are displaying their incompetence. You have confirmed that this Dumb DOFO Government have proven to be as such. That is hilarious!!
 
What plates do you expect them to hand out in the meantime? No more old ones and there still is a need to issue plates.
So what’s your contingency if no more old plates available?

And once again, you demonstrate that you have absolutely no clue what a contingency is.
I'm feeling generous, so I will give you a hint... Contingency: make sure that there are enough old plates available on hand in the (likely) event that our (non) planning blows up in our faces and we need to cancel this (haphazard) rollout.
I'm sure I just put some unnecessary wear and tear on my keyboard... you won't understand the above.
 
If the Government are purchasing thousands of licence plates, you are telling me the they would not get a sample of that plate in advance especially if it is customized to suit the Government's choice??

The assurances from manufacturers will be in the form of warranty that they will operate as such based on what was submitted to the customer in advance of the mass production of them. Any company that buys such products that they will be reselling, will expect to see and to test out that quality prior to approval for the manufacture of these products. If they do not follow these basic protocols then they are displaying their incompetence. You have confirmed that this Dumb DOFO Government have proven to be as such. That is hilarious!!

So it sounds like you are stuck on who was responsible for the testing. Because in your opinion proper testing would have discovered the reflection issue.
Have you stopped to ask yourself who specifically would be responsible for conducting the tests?
Law enforcement was consulted. Apparently they had no issues with them.
But you are hell bend on blaming Ford?
That's a stretch.
 
If the Government are purchasing thousands of licence plates, you are telling me the they would not get a sample of that plate in advance especially if it is customized to suit the Government's choice??

The assurances from manufacturers will be in the form of warranty that they will operate as such based on what was submitted to the customer in advance of the mass production of them. Any company that buys such products that they will be reselling, will expect to see and to test out that quality prior to approval for the manufacture of these products. If they do not follow these basic protocols then they are displaying their incompetence. You have confirmed that this Dumb DOFO Government have proven to be as such. That is hilarious!!

Whoa there bver... you're expecting wayyy too much...
Asking dumbo to make sure that one of his cronies got off their lazy ass, put a prototype plate on a car, wait until it was dark, then shine some headlights on the prototype... that is completely unreasonable and absolutely unfair... apologize immediately!!!
 
And once again, you demonstrate that you have absolutely no clue what a contingency is.
I'm feeling generous, so I will give you a hint... Contingency: make sure that there are enough old plates available on hand in the (likely) event that our (non) planning blows up in our faces and we need to cancel this (haphazard) rollout.
I'm sure I just put some unnecessary wear and tear on my keyboard... you won't understand the above.

You think the government would be stockpiling old plates in enough capacity to roll back new plates? Has there ever been a government who did this when rolling out new plates?
And why would they roll out the old plates if they also had defects?
Jeezus you are desperate to misplace blame.

You think child seat manufacturers give people the old design seats when they issue a recall for a newly discovered defect with the new models?