Question about gas..chemistry...fire..etc..

fmahovalich

Active member
Aug 21, 2009
7,256
25
38
So...if I were to set up a metal can of gas...say in a metal juice can.

Then I were to light a candle under it...

And place it in a closed room...

Would it eventually heat up (boil if flame hot enough)..

Or would vapour fill the room....

AND At the exact right second...KABOOM??
 
Who are you looking to get rid of?
 
Depends. Are you writing an episode of CSI? Then it would explode for sure. In the real world, I dunno.
 
Depends on the lower flammability limit/ upper flammability limit. Depending on the gas vapour, each has a range that can be ignited and has to be between the LFL/UFL. If below or above, it will be too lean/rich and will not ignite.
 
Shall we begin by reminding ourselves that gas means vapour, and that the proper name for the auto-fuel is gasoline, so called because of its readiness to turn from liquid into gas.

Lotta variables undefined: how big the room, how much gasoline, how big the flame, how long will the candle last, is it near the ceiling or near the floor and is the room warm enough to keep the gas a gas or coolm enough that it would condense. Are you talking about trying to have an explosion (like an SFX guy for a film, or for that novel you're writing) or about staying safe?

Boiling in an open container does allow the possibility of the small amounts of vapour to be harmlessly burned as they are emitted. If I wanted an explosion I think I'd use a container that confined the vapor until pressure caused it to rupture and deliver a large quantity of vapours to the flame at an instant.
 
having played around with gasoline now and again - living in the country you have to make your own entertainment and this was before the days of the internet :)

If you fill a paper cup - say a Timmie's cup with gasoline and sent it on a fire the cup will not burn at first because the gasoline will boil at a lower temperature than the combustion point of paper. But in that boiling it splashes gasoline outside of the cup and ends up setting the gas inside the cup aflame.

So unless your metal container was big enough to prevent that "splash out" you wouldn't get a buildup of flammable gas vapours. If it was, and the room was air-tight enough and you had the right volume of gasoline then I imagine that it would indeed go "boom" when the air:gas ratio hit the proper levels for ignition.
 
what you really would not want to do is put the gasoline into a sealed container with a pressure release valve of some kind .......
 
It will catch fire before the room is completely filled with gas, so not a big explosion, but localized fire around the gas can.

According to http://en.wikipedia.org/wiki/Flash_point, flash point of gasoline is -43 *C, while autoignition point is 246 *C. Candle flame has a temperature of over 500 *C so it will for sure ignite the gas vapour. And because it is so close to the source of vapour it will most likely ignite it before you have a chance to fill the entire room.

If you want to fill the whole room with gas vapour before igniting, use a portable eletric stove, set the temperature to just over the autoignition point, I would set to 300 *C to be safe that it will ignite. Place the gasoline can on top of the stove, turn it on, seal the room and run away. Eletric stove increases the temperature gradually, evaporating the gasoline to fill the room. After 5 - 10 minutes, it reaches the ignition temperature, and the whole room will explode.
 
Uh, TVA, you might want to take the minus sign out of the flashpoint temp. you gave. I suspect you meant 43ºC, and later 246ºC, etc. If your keyboard's like a Mac's the degree symbol is made with the Option and Zero key combo, Option being the second key left of the Space Bar.

It was creative using the asterisk, but when we're talking explosions, I think we should eliminate every possible ambiguity in the info.
 
This thread should be removed. It is dealing with potentially deadly experiments. Not suitable for general public.
 
Uh, TVA, you might want to take the minus sign out of the flashpoint temp. you gave. I suspect you meant 43ºC, and later 246ºC, etc. If your keyboard's like a Mac's the degree symbol is made with the Option and Zero key combo, Option being the second key left of the Space Bar.

It was creative using the asterisk, but when we're talking explosions, I think we should eliminate every possible ambiguity in the info.

No, -43 would be about right... The flashpoint is the temperature at which a given substance begins to vapourize. Below this temperature ignition is impossible (as it's the vapours that burn, not the liquid) - above this temperature, it will burn...
 
There we go, guess that's howcum cars start in the cold. Thanks for making it clearer.

Considering you can actually set type for print with these 'puters right outta the box—never mind they all have spellcheck and some do grammar ckecks—we really owe ourselves a higher standard of clarity and accuracy than we commonly see. Where is that degree symbol on a PC keyboard anyway?
 
So...if I were to set up a metal can of gas...say in a metal juice can.

Then I were to light a candle under it...

And place it in a closed room...

Would it eventually heat up (boil if flame hot enough)..

Or would vapour fill the room....

AND At the exact right second...KABOOM??

The truly scientific answer is this:

Give it a try and let us know what you observe.
 
It'd be that "…exact right second" we'd all want to know about.
 
If OP is plotting a murder, gasoline would be very ineffective because of the odour it gives off will warn the victim, unless the victim is sound sleep or sedated. A better substitute would be diethyl ether, which is just as flamable as gasoline and its vapour has anesthetic effects so that the victim will not wake from the smell.
 
If OP is plotting a murder, gasoline would be very ineffective because of the odour it gives off will warn the victim, unless the victim is sound sleep or sedated. A better substitute would be diethyl ether, which is just as flamable as gasoline and its vapour has anesthetic effects so that the victim will not wake from the smell.

Gasoline inhibits the smelling sense, so you only smell it for a little while.