Chimney Question

SkyRider

Banned
Mar 31, 2009
17,546
2
0
When I look at my rooftop chimney from the ground, I think I see two pipes sticking above the brick top. Why are there two pipes and not just one?
 
One is for the furnace, the other a fireplace - assuming you have a fireplace (or did have one)
 
A gas furnace or hot water heater will be vented up the chimney.
 
Take a picture & post it here, otherwise we're all guessing.

But if you have a furnace that still uses a chimney, I'd suggest you do as your neighbour is doing & replace it with a hi-efficiency while the gov't rebates are still available.
 
Seth, he doesn't have a "chimney". the exhaust venting for the furnace/hot water tank just use it as an easy out.
 
A gas furnace or hot water heater will be vented up the chimney.

My neighbor also has two pipes sticking up above her brick chimney. I assume that her low efficiency furnace and low efficiency water heater are connected to the chimney, but why two pipes and not just one pipe?
 
Chimney might not be wide enough. Like i mentioned in the other thread tying the two together into one pipe would cause an increase in pipe size. two 3 " vents would terminate into a 5 inch vent if u were tying in together. Might not have been a wide enough space in the chimney to run a 5 inch liner so instead they were forced to install individual liners. You can tell usually if your water heater and furnace are piped in together because it will be done before it goes into your chimney(meaning you will be able to see the tie in somewhere around your furnace and water tank in the form of a T or Y branch)

Alot of times with older chimneys as well theyll have bricks sticking out on the inside and there inside diameter is alot smaller than it looks from the top. Stuffing a single 5 or 6 inch chimney liner down these older chimneys can be bruuutal.
 
I tried to do some research on Google and it appears that the two pipes sticking up above the chimney might be an "H-Cap". What is an "H-Cap"?
 
Why don't you just follow the pipes from the base of your chimney in the basement and see where they lead?
 
How old is your house? Check if your furnace is vented through the chimney. If so that's one flue. Do you have a firePlace? If yes that's the second flue. If one of the able answers is no then is probably a dummy flue. It means that only the top part was installed just to make the chimney look better.
 
Check if your furnace is vented through the chimney. If so that's one flue.

Before I installed the HE furnace, I seem to recall that the water heater and the old furnace were joined before they enter the chimney. I also have a 5" chimney liner. So, I think I have only one flue but I see two pipes sticking out of the top of the chimney.