Viewsat free to air problem

slashaxl

Well-known member
Dec 27, 2004
1,218
133
63
I have a viewsat satellite system but have a problem. I have a diseque switch and I can't get both echostar 7 & 8 satellites to work simulataneously. If I use a specific input jack on the switch, either 7 or 8 works so I know the dish is receiving them.

I tried changing the port locations on the installation menus, same problem.

Wonder if anyone else has any ideas.

Thanks
 
slashaxl said:
... I have a diseque switch and I can't get both echostar 7 & 8 satellites to work simulataneously...

Assuming you have selected the ports correctly in antenna setup, it's likely a bad switch. Cheap Diseqc switches are infamous for going bad.

If you are only using echostar 7 and 8/10, try using a 22 Khz switch ($5-7) or a sw21 ($5-7) instead as they are more reliable. If you need more than 2 ports, try another diseqc switch (about $3 each)
 
Last edited: