Upgrading to 100 amp service question

wawa

Well-known member
Jan 15, 2004
329
270
63
I've moved into a house with 60 amp service with fuses. I want to upgrade to 100 amp service with circuit breakers. One electrician states that the local hydro provider must be involved in order to inspect the work and upgrade the incoming cable to 100 amp. The second electrician states that he can change the panel and install circuit breakers without involving the hydro provider leaving me with a 60 amp input cable and 100 amp panel. This option doesn't sound right to me, even though he says that this is legal. The first electrican hasn't even given me a cost after 3 weeks. I think the option of involving the hydro provider and upgrading the incoming cable to 100 amp is best. Any input would be appreciated. Thanks
 
Not sure how big the house is but,..... most newer homes 200A wires incoming, and 200A panel is norm now, for washer, dryer, etc, split circuits for the kitchen.... whole cost sould be $2500 - $3000. I'v done it 3 times, in the last five years.
Good luck, always better to have more power, then doing the just twice. Yes, electrician needs Toronto Hydro, or supplier for updated cables. Electrician, can do all the work, once the wires come in from the street, buried or above ground.
 
Obviously you have a much older home/cottage. Get quotes from three certified electrical contractors. It's an easy job for them. The local area hydro provider does have to make an inspection and it could be 2-3 inspections depending on the how much work is involved, or as little as 1. Don't go with the cut rate/fly-by-night guy. If a problem crops up you could be on the hook for paying another contractor to do the job right. Do the job right the first time and only pay once.
 
By law which some people never bother about, there is "suppose" to be an ESA inspection once work is done. ESA is suppose to happen to make sure you don't burn down the whole street BUT even with inspection the whole street does burn down...hence the "supposed" inspection :)
 
The second electrician states that he can change the panel and install circuit breakers without involving the hydro provider leaving me with a 60 amp input cable and 100 amp panel.

Use the second electrician to wire up your grow-op. It sounds like he is familiar with that class of work.

For your house, the first electrician is either extremely busy, does not really want the work, or doubts you will pay his rate. In any case, he is correct in what you need to do.

You might be well advised to either:
a) Go straight to a 200(A) panel, or
b) Simply wire a sub-panel to the main 60 (A) panel, and wire all your power into the new sub-panel. At least with the sub-panel approach, you can keep all your new wiring if you need to switch out the main service later.

If your insurance ever inspects your house, you need a minimum of a 100(A) panel and a proper install. Real estate agents can tell the difference by glancing at the outside of your house.
 
Thanks for all replys so far. We have downsized to an older townhouse of only about 1600 square feet so probably only need a 100 service or would 200 amp be overkill?
 
200 amp overkill except for very large homes. The proceedure can be different depending on what city/town you're in, but you will need to involve hydro and it will have to be inspected by ESA. Hydro will not reconnect until ESA gives them the go ahead. The second electrician is wrong. After the upgrade is done, the electrician will re-connect to the old wiring on a temporary basis but to avoid hydro is definitely breaking the law. It breaks several actually, including opening a meter without permission which can result in a hefty fine.