Tuck pointing, any experts out there?

Doctor Zoidburg

Prof. of Groinacology PhD
Aug 25, 2004
1,155
23
38
I just bought a building that has some mortar missing in the bricks. Is it as easy as pushing some new mortar into the bricks, or is there more to it than that. Do I need to put in a special mortar and is there anything I should watch out for?
I would appreciate any info.
 
Doctor Zoidburg said:
I just bought a building that has some mortar missing in the bricks. Is it as easy as pushing some new mortar into the bricks, or is there more to it than that. Do I need to put in a special mortar and is there anything I should watch out for?
I would appreciate any info.

Sorry doc, I thought you said "Fuck Pointing".
 
You need to clean the area.

If it is a small job I believe there a tube of stuff you can buy at the hardware store. You may not need to mix up a whole batch.
 
No "free masons" out there?
 
Doctor Zoidburg said:
I just bought a building that has some mortar missing in the bricks. Is it as easy as pushing some new mortar into the bricks, or is there more to it than that. Do I need to put in a special mortar and is there anything I should watch out for?
I would appreciate any info.

It is not that difficult, but it takes a lot of patience for an amateur bricklayer. You buy the point mortar of the appropriate colour, make a fairly dry paste and push it into the space between the bricks.

Firsyt you remove all loose point mortar, and what is important, you wet the bricks well before you push in the mortar.
 
If you're dealing w/ old, soft bricks—say from the '20s—you'll want to try to get old-fashioned lime mortar. The modern-day formulations w/ all-portland cement cure harder than the brick, then as bricks and mortar do the wet/freeze/expand/thaw cycle, the hard mortar cracks and spalls the bricks.

Googling: 'How to tuck point bricks' gets some promising-looking pages.
 
Last edited:
oldjones said:
If you're dealing w/ old, soft bricks—say from the '20s—you'll want to try to get old-fashioned lime mortar. The newer formulastions w/ all-portand cement cure harder than the brick, then as bricks and mortar do the wet/freeze/expand/thaw cycle, the hard mortar cracks and spalls the bricks.

Googling: How to tuck point bricks gets some promising-looking pages.

Exactly.

You also need to seriously wet the brick and mortar left in the joint prior to pointing otherwise, the bricks will suck the water right out of your new mortar and the mortar will crack.
 
I know this is of no help but freaky that I was behind a van claiming to be tuck point specialists and I couldn't help but think WTH is that?!???? Now I know. :)
 
After consulting with Lupe,
I have concluded that you will need
one "tuck" and one "no tuck"

By the way how much do you tip a chambermaid?


</Seinfeld>