Rogers High Speed + Laptop Question?

homer

Well-known member
Aug 18, 2001
16,326
107
63
People:

Feel free to laugh at my total lack of techie skills if you wish! I have a question regarding my internet connection. My PC is currently on Rogers high speed, and a friend (equally inept) has a laptop. She uses dial-up (lives way out in the sticks!) and needs to download something large. Anyway, my question is, can we just unhook my pc connection, into her laptop and expect High speed access? Or do I have to do something, like login etc? Sorry for the dumb question, but we really do need to know!

Thanks
 
The answer will depend in part on whether your PC is connected directly into the cable modem, or if you have a home router connected between them.

The long answer is that she can bring her laptop to your place, connect it instead of your PC, reset the cable modem by powering it off for about 30 seconds (then back on), and then she'll be able to use the High speed access. To reconnect it back to your computer, you'll have to reset the cable modem again.

This is because the cable modem "remembers" what device was connected to it. If you have a home router, that's the device that is "officially" connected to the network. If your computer is directly connected, that's the device that's remembered. Swapping devices can't be done successfully while it still has the other device in memory. A power reset of the cable modem is the easiest way of having it "forget" what was previously connected.
 
Thanks!

This is what makes TERB great! Anynym, my PC is connected directly, so I will give your advice a try. Thanks again!

Homer
 
actually the last time I was on Rogers high speed service you had to actually 'release' the IP from your computer and then plug in the new computer. Admittedly it has been a long time since I used Rogers and it may have changed.
I had this problem when just switching a network card in the same computer, the modems are locked to the MAC address of the network card you are using.
If you release the IP it also releases that lock. Power cycling the modem does not always do this.

on your computer
go to start > run > type 'cmd' (without the quotes)
it will come up with a console window (or DOS window)
type 'ipconfig /release' (again without the quotes, and make sure you have a space between the g and the / )

Unplug your computer, plug hers in, boot it up and you should be good to go
You may have to set up her network settings though, you should just be able to set it to receive an IP automatically (DCHP) and it should work fine.
 
I concur with Sasha's advice. (My experience was that leaving the cable modem powered off for at least 30 seconds would release the address, but Sasha's approach is more correct.)

Don't forget to do the same "ipconfig /release" on her computer before you reconnect your own (or else you just might be hoping that the modem will release the address by leaving it powered off for a while, to allow you to reconnect)