Plumbing question...

The Bandit

Lap Dance Survivor
Feb 16, 2002
5,753
0
0
Anywhere there's a Strip Joint
What could cause a single lever kitchen faucet to work solely on hot or cold (left or right), but when you try to use it in the middle (hot and cold), you get no water and the pipes hammer. I have to take a look at it tomorrow evening for a friend.
 
What is the brand / I say something is clogged.

On Moen single handles there is a cartridge you can replace. Its around $20, you shut the water off and take the handle off and remove a clip. They give you a plastic piece to place over the old cartridge to break it free, you just turn it and then pull the old cartridge up and install the new cartridge.

If its some no name brand it might be best to just replace, they aren't too much and its not very hard to change, unless you are too big to crawl under the sink.
 
This is one that was working fine, correct?
 
.

On Moen single handles there is a cartridge you can replace. Its around $20, .......................

Cartridges are guaranteed for life, they (retailers and Plumbing suplliers) are not supposes to charge for replacements....
 
What / tell Home Depot that, maybe I say something next time cause they aren't cheap:cool:
 
Agreed. Changing the cartridge should fix the problem.
 
Hmmm, it got damage somehow. I really can not see how it could be hooked up wrong. Likely best to replace it.

Oh air sometimes gets in the pipes. Run the faucet full blast on both sides a few mins..if you hear the pipes knocking at all its the air getting out of the lines. Not sure if that is the problem, don't think so but will not hurt to try.

Somebody may have tossed the faucet after it was off and damaged it, or dirt got it somehow. Maybe running it full blast might clean it out.