any electrical motor experts?

ILOVETHIS

Member
Jun 12, 2006
452
2
18
I have a question

I'm driving a servo motor with 20Vrms.

When I put an oscilloscope across it, why is there an increasing unpulsed DC component that corresponds to the motor’s increasing speed?

any input would be great. thx
 
How can you drive it with a Vroom? ISn't that the sound it makes when it goes? Vroom Vrooms!
 
Why not use a flux capacitor instead?

Because there might be a danger that you will be transported back in time and emerge from one of L of Ts orifices, which orifice is not guaranteed. Would you be willing to take that chance?


23vf34n.jpg
 
I have a question

I'm driving a servo motor with 20Vrms.

When I put an oscilloscope across it, why is there an increasing unpulsed DC component that corresponds to the motor’s increasing speed?

any input would be great. thx

If you have an SCR drive, the waveform will change with output voltage. You can get an approximate prediction by playing with a simulation of firing angles vs. sine wave position in Excel.

If you have an IGBT or MOSFET drive, you should see a high frequency switching waveform.

If the output of the drives are well filtered, you will also see a pulsing DC component due to the commutation of the DC motor and changes inside the magnetic circuit of the motor. This will also correspond to the torque ripple on the output of the motor. This effect will be particularly visible when measuring motor current. Excessive DC pulsing can be a leading indicator of motor failure.

If the output of the drives are not well filtered, you will see complex harmonic intermodal distortion between the SCR/IGBT/MOSFET effects and the commutation inside the motor.

If these effects are important to your application, PM me.
 
Last edited: