It's not a question of utilizing my Internet connection to its full capacity. Hardly.
It's a question of exponential decay in speed due to the structure of the house. With Bell I have their Fibe 150 service. Speeds fall off a cliff the further I am from the modem. To the point that the WiFi signal is less than one tenth of what it is if I'm sitting beside the modem. Signals degrade with distance and the structure of the house. (And I don't think you want an electromagnetic signal so strong that it can rip right through masonry and timber and plaster (I live in an old house over 100 years old. Double brick walls and stone foundation walls.))
The Belden Cat 6 eliminates the issue entirely. It's vastly superior to wireless.
I'm not afraid to pull cables and crimp some fittings.
Any electronic guru will allays tell you that hard wired anything is always superior to wireless. Be that data, alarms, communication, or even a simple thermostat.
I was actually in the same situation as you a year ago. I lived in a decent sized old house and the wireless signal would drop around half of the house. I propose 3 solutions for you:
1. I'm guessing you're using the free router that Bell gave you. Try replacing it with a good aftermarket one and it should be sufficient.
2. Run an Ethernet cable to the room / area where signal is low and attach it to a WiFi extender
3. Just use a dongle, with Bell 150 your max speed is only 150Mbs which is quite slow and won't even be bottlenecked by USB 2.0.
Also make sure you’re using the 2.4Ghz band of your wireless signal, not the 5Ghz. The 2.4Ghz waves pass through surfaces much easier.
Not sure if you're rewiring the house but if you're trying to future proof your connections, wireless is the future. More devices will be made without RJ45 ports, especially smart home stuff so investing in wireless will be much better in the long run.
Wired connections have their place, when stability, speed and redundancy are key. Such as for servers and security systems. But for general use wireless is sufficient, especially when you’re only working with 150Mbs. A ethernet port on an laptop will just tie you down and will make the laptop thick.