High Efficiency Furnace Questions

Tankless normally use concentric kits. Concentric kits draw freash air and release exhaust all in one pipe. Normally it is a 5 inch pipe with a seperate 3 inche pipe inside of it for exhaust and the 2inches surrounding the inner pipe draws your fresh air. Yes they are also vented through a wall same as 636.

Thanks, how high is this pipe (5" is a large hole in the wall) above ground level? I hate to get toxic exhaust if it is too low.

My neighbor said that she could run her HE furnace pipes through her front wall (a bit more of a run but doable). The problem is that the exhaust pipe would still be only about 8" to 12" from my property so I would likely still get some or much of her exhaust. My own installer said that she should point her nozzle away from my property but if the wind is blowing in my direction I will still get her exhaust.
 
If it's running properly isn't the exhaust pretty much just CO2 and water vapour?
 
There are a couple of posts that said the stuff that come out of those vents is poison.

There are posts on the Internet that the world is flat, doesn't mean it's true :). As long as her pipe terminates at the minimum distance away from any openings you shouldn't have any problems. Not like she's burning coal after all.
 
'Poison' and 'toxic' and other such words must be applied in context, not taken literally as if a mere whiff was deadly like in sci-fi flix. Arsenic is a notorious poison, but workers who retired from working in plants where it was produced were given weekly supplies because long exposure had addicted them. Coal smoke is toxic, but until the '50's that's how London was heated, with no treatment of the smoke whatsoever. Eventually enough people died every time there was a 'fog' (See also : Smog, Los Angeles) that coal was phased out. It was always toxic, at a certain point in time it became unacceptably so; opinion changed, the fumes did not.

The gases from an HE furnace are toxic, but in the tiny dosages you might ingest from a properly vented appliance, they will do you no measurable harm. At least that is the science—including the administrative political science—as it stands now. And it's the imperfect laws that follow the poli-sci that restrict us and our neighbours.

It isn't that the stuff is toxic (as we all know), but how toxic the law says it is and how it says we are to cope with that. The only sure thing is that you will die. Someday. But if we got the laws and regs right, not from an improperly vented furnace.

As long as we remember that writing and enforcing such rules is meat and potatoes of government and not the gravey.
 
Just walking around Toronto, I see quite a few of these pipes sticking out of walls in ever which way. Some of the exhaust pipes are at waist level (eye level if you are a kid). These were probably installed prior to the current code which I think requires a minimum height of 7 feet.
 
There are posts on the Internet that the world is flat, doesn't mean it's true :). As long as her pipe terminates at the minimum distance away from any openings you shouldn't have any problems. Not like she's burning coal after all.

When I was a kid a family died from carbon monoxide posioning on my street (not the whole family 3 out of 4, the mother survived.). All due to a blocked exhaust on a furnace and a failed Hi limit switch. If that's not poisonous enough for you then I don't know what is. (also why we have carbon monoxide detectors in every house)

The thing about minimum distances is it allows most of it to disperse in the air first, so it is not near as dangerous as say it happening in a closed environment like your house.
 
Just walking around Toronto, I see quite a few of these pipes sticking out of walls in ever which way. Some of the exhaust pipes are at waist level (eye level if you are a kid). These were probably installed prior to the current code which I think requires a minimum height of 7 feet.


Once again skyrider, this code for 7 feet only applies to COMMON walkways (example... sidewalks, arena's, community centres). Which to be honest with you the majority of the pipes you see sticking out of the wall are on someones private property.(not common walkways)
 
We could all get together and hire some experts to actually look at installation plans and whether what got done lived up to the plan, met the code and was properly done to best practices. We could call then, hmm let's see, City HVAC Inspectors, and when we saw their approval sticker, we'd have some confidence the install was OK.

Or we could rely on TERBitalls 'cause gravy like that's too expensive for TO.
 
I notice HE furnaces have two pipes protruding from an exterior wall. Am I correct to assume the lower one is to bring outside air into the furnace (why?) and the higher one is to release the exhaust from the furnace? Also, how toxic is the exhaust fume (is it worse than car exhaust) and why can't it be released into a chimney like the older furnaces?

All High Efficiency furnaces have 2 plastic 636 pipes. The lower one is for air intake for combustion and the 2nd is for exhausting flue product. Much safer then the a standard or mid efficiency furnace.
As far as the exhaust that comes out on the other end - if he calibrated the the furnace regulator (providing it's not a variable speed furnace) and did a flue gas analysis it shouldn't be lethal. But no one every does that shit. Time is money. They install it and that's it.

Note - If you ever have problems with your furnace check the small window, you should see a flashing light (take note as to how many times it flashes before it stops). Then open the door, you should see the light flash code's on the inside of the door (don't worry, the furnace will shutdown - Safety door switch will trigger). Most modern furnace's are self diagnosing and some even have USB input to check via computer (not to many models have this though).

Also another thing to keep in mind is, high efficiency furnace's are basically condensing furnaces. Which means you'll have a lot of condensate (water) coming down from your flue (exhaust pipe) to a clear rubber pipe (with one loop) (usually) which goes to the drain. Make sure that the water can flow freely. sometimes it get's clogged and you get a water everywhere. Usually you just have to give it a good blow job and it should clear right up.

Well, that should save you a couple bucks down the road :)
 
We could all get together and hire some experts to actually look at installation plans and whether what got done lived up to the plan, met the code and was properly done to best practices. We could call then, hmm let's see, City HVAC Inspectors, and when we saw their approval sticker, we'd have some confidence the install was OK.

Or we could rely on TERBitalls 'cause gravy like that's too expensive for TO.

Or you can wait til march and I get my gas inspectors license. :eyebrows:
 
We could all get together and hire some experts to actually look at installation plans and whether what got done lived up to the plan, met the code and was properly done to best practices. We could call then, hmm let's see, City HVAC Inspectors, and when we saw their approval sticker, we'd have some confidence the install was OK.

Or we could rely on TERBitalls 'cause gravy like that's too expensive for TO.

Third option - use the TSSA, because that's already what they do........cheaper than starting up a city HVAC inspection division to do the same function.
 
Third option - use the TSSA, because that's already what they do........cheaper than starting up a city HVAC inspection division to do the same function.

Right, but not every Hvac job is inspected. Majority are done very cheap, under the table. You just hope that the person installing it at least has a TSSA contractors license... haha

Its a different ballgame when it comes to commercial, but still, an inspector is there to find obvious problems. He'll never see everything.
 
Third option - use the TSSA, because that's already what they do........cheaper than starting up a city HVAC inspection division to do the same function.
So SkyRider should call the TSSA to tell him where his neighbour may vent her proposed HE furnace—and more to the point where not—or does he wait until he sees the truck in the drive, then saunter over and ask for the TSSA inspection-order number?

Certainly we shouldn't be duplicating services, but there's really no reason why a provincial body would be cheaper than a municipal one, and in the end no matter who you make out the cheque to, it's still you signing.
 
The conversation with my neighbor just got a bit more complicated. She is now complaining that the emission from my HE furnace vent is traveling across my property and hitting her brick wall more than 2 feet away. She is claiming that the emitted gas hitting her wall is damaging her bricks and motar. Is she making any sense?
 
So SkyRider should call the TSSA to tell him where his neighbour may vent her proposed HE furnace—and more to the point where not—or does he wait until he sees the truck in the drive, then saunter over and ask for the TSSA inspection-order number?

Certainly we shouldn't be duplicating services, but there's really no reason why a provincial body would be cheaper than a municipal one, and in the end no matter who you make out the cheque to, it's still you signing.

In his thread regarding property rights, where the issue of the neighbour's furnace installation originated, based on the info Skyrider gave, the applicable code reference was provided which pretty clearly indicated that the installation cannot be done to code, along with the advice to call the TSSA if they proceed with the installation as originally described.
The TSSA will come inspect the install, find that it is not to code, and pursue the installers. There are some substantial fines involved, and it will be the contractor who will be paying the TSSA (they are a self-funding agency). If the contractor is a complete fly-by-nighter who disappears after the job, the homeowner will have to get the code deficiency rectified at their expense. But that furnace will most surely be shut down if the code violation constitutes a health/safety risk.
Its a pretty good system when people are aware of it and use it, in that it will pursue AND punish incompetent and/or dishonest contractors. But theres also a "buyer beware" aspect to it, in that if some guy gives you a ridiculously lowball price on the furnace install, he's most likely cutting corner with your safety.
 
The conversation with my neighbor just got a bit more complicated. She is now complaining that the emission from my HE furnace vent is traveling across my property and hitting her brick wall more than 2 feet away. She is claiming that the emitted gas hitting her wall is damaging her bricks and motar. Is she making any sense?

Her proposed install was not to code.
Sounds to me like your neighbourly relations have just gone south for the winter.
Rather than asking for advice on an escort board, where only a few poster have shown any expertise on the subject of furnaces, you might want to get a licensed professional involved for a face-to-face meeting with you & your neighbour, before the relations get even worse.

Good luck to you!
 
The conversation with my neighbor just got a bit more complicated. She is now complaining that the emission from my HE furnace vent is traveling across my property and hitting her brick wall more than 2 feet away. She is claiming that the emitted gas hitting her wall is damaging her bricks and motar. Is she making any sense?

No. Is there any actual visible damage lol... that sounds so bogus
 
you might want to get a licensed professional involved for a face-to-face meeting with you & your neighbour, before the relations get even worse.

I did call my own installer. (These guys are unbelievably busy.) He did a "drive by" to take a look, but I wasn't home. He called me on his cell later (terrible reception) and said the code won't allow my neighbor to do what she wants. My installer then said he had to go, had a job that was running late.